| A study on the maximum temperature of ceiling jet induced by rectangular source fires in a tunnel using ceiling smoke extraction |
36 |
| Numerical investigation of rectangular-cut twisted tape insert on performance improvement of heat exchangers |
24 |
| Thermal management of lithium ion batteries using graphene coated nickel foam saturated with phase change materials |
23 |
| Entropy generation and heat transfer in boundary layer flow over a thin needle moving in a parallel stream in the presence of nonlinear Rosseland radiation |
22 |
| Battery thermal management system for electric vehicle using heat pipes |
21 |
| Convective heat transfer and entropy generation analysis of non-Newtonian power-law fluid flows in parallel-plate and circular microchannels under slip boundary conditions |
20 |
| An experimental investigation on forced convection heat transfer of single-phase flow in a channel with different arrangements of porous media |
19 |
| Supercritical boiling number, a new parameter to distinguish two regimes of carbon dioxide heat transfer in tubes |
19 |
| Correct interpretation of nanofluid convective heat transfer |
18 |
| A comparative study on the thermal performance of water in a circular tube with twisted tapes, perforated twisted tapes and perforated twisted tapes with alternate axis |
18 |
| The role of convection in gas and liquid phases at droplet evaporation |
18 |
| Outlining the impact of induced magnetic field and thermal radiation on magneto-convection flow of dissipative fluid |
17 |
| Optimization of finned solar photovoltaic phase change material (finned pv pcm) system |
17 |
| Effects of ambient pressure on transport characteristics of thermal-driven smoke flow in a tunnel |
17 |
| A novel hybrid thermal management for Li-ion batteries using phase change materials embedded in copper foams combined with forced-air convection |
16 |
| Simultaneous effects of melting heat and internal heat generation in stagnation point flow of Jeffrey fluid towards a nonlinear stretching surface with variable thickness |
16 |
| Non-isothermal evaporation in a sessile droplet of water-salt solution |
16 |
| Experiments on mist flow and heat transfer in a tube fitted with porous media |
16 |
| Thermo-hydraulic performance of solar air heater having twisted rib over the absorber plate |
15 |
| Two-dimensional analysis of low-pressure flows in an inclined square cavity with two fins attached to the hot wall |
15 |
| Turbulent natural convection combined with thermal surface radiation inside an inclined cavity having local heater |
15 |
| Selected porous-ribs design for performance improvement in double-layered microchannel heat sinks |
14 |
| Developed correlations for heat transfer and flow friction characteristics of louvered finned tube heat exchangers |
14 |
| Influence of particle properties on convective heat transfer of nanofluids |
14 |
| Thermal-hydraulic optimization of plate heat exchanger: A multi-objective approach |
14 |
| Thermal-hydraulic performance of interrupted microchannel heat sinks with different rib geometries in transverse microchambers |
14 |
| Multiple patterns of heat and mass flow induced by the competition of forced longitudinal ventilation and stack effect in sloping tunnels |
14 |
| A computational study of heat transfer analysis for a circular tube with conical ring turbulators |
14 |
| Heat transfer characteristics of concave and convex curved vortex generators in the channel of plate heat exchanger under laminar flow |
14 |
| Mixed convection heat transfer in a differentially heated cavity with two rotating cylinders |
13 |
| Numerical study on overall smoke control using naturally ventilated shafts during fires in a road tunnel |
13 |
| Numerical and experimental study on drying shrinkage-deformation of apple slices during process of heat-mass transfer |
13 |
| Pool boiling heat transfer of N-pentane on micro/nanostructured surfaces |
12 |
| Heat and mass transport phenomena of radiated slender body of three revolutions with saturated porous: Buongiorno's model |
12 |
| Explosive boiling of nano-liquid argon films on high temperature platinum walls: Effects of surface wettability and film thickness |
12 |
| Influence of fin size and distribution on solid-liquid phase change in a rectangular enclosure |
12 |
| Hotspot thermal management using a microchannel-pinfin hybrid heat sink |
12 |
| The role of gamma Al2O3 - H2O and gamma Al2O3 - C2H6O2 nanomaterials in Darcy-Forchheimer stagnation point flow: An analysis using entropy optimization |
12 |
| Combined heat and mass transfer analyses in catalytic microreactors partially filled with porous material - The influences of nanofluid and different porous-fluid interface models |
12 |
| The drop-in of HFC134a with HFO1234ze in a household refrigerator |
12 |
| Effects of fins geometries, arrangements, dimensions and numbers on natural convection heat transfer characteristics in finned-horizontal annulus |
12 |
| Combustion characteristics of a common rail direct injection engine using different fuel injection strategies |
12 |
| On the study of keyhole-mode melting in selective laser melting process |
12 |
| PCM charging process accelerated with combination of optimized triangle fins and nanoparticles |
12 |
| Constructal design of nonuniform heat generating area based on triangular elements: A case of entropy generation minimization |
12 |
| Experimental investigation on the hydrothermal performance of a double-pipe heat exchanger using helical tape insert |
11 |
| Enhancement of thermal and hydraulic performance of compact finned-tube heat exchanger using vortex generators (VGs): A parametric study |
11 |
| Effect of different surfactants on the pool boiling heat transfer of SiO2/deionized water nanofluid on a copper surface |
11 |
| Effect of the perforation design on the fluid flow and heat transfer characteristics of a plate fin heat exchanger |
11 |
| CFD modeling of macro-encapsulated latent heat storage system used for solar heating applications |
11 |
