| Detailed Modeling of Melt Dripping in Coke Bed by DEM - SPH |
13 |
| A Review of the Chemistry, Structure and Formation Conditions of Silico-Ferrite of Calcium and Aluminum ('SFCA') Phases |
13 |
| Shear-Force Based Stainless Steel Slag Modification for Chromium Immobilization |
13 |
| Key Lubrication Concepts to Understand the Role of Flow, Heat Transfer and Solidification for Modelling Defect Formation during Continuous Casting |
10 |
| Viscosity Property and Melt Structure of CaO-MgO-SiO2-Al2O3-FeO Slag System |
10 |
| A Review of Fluorine-free Mold Flux Development |
10 |
| Overview of Dynamic Strain Aging and Associated Phenomena in Fe-Mn-C Austenitic Steels |
9 |
| Effects of CaCO3 as Additive on Coal-based Reduction of High-phosphorus Oolitic Hematite Ore |
8 |
| Effects of CaO/SiO2 on Viscous Behaviors and Structure of CaO-SiO2-11.00wt%MgO-11.00wt%Al2O3-43.00wt%TiO2 Slag Systems |
8 |
| Effect of CaO/Al2O3 Ratio of Ladle Slag on Formation Behavior of Inclusions in Mn and V Alloyed Steel |
8 |
| Effect of TiO2 and MnO on Viscosity of Blast Furnace Slag and Thermodynamic Analysis |
8 |
| Numerical Simulation of Multiphase Flow and Mixing Behavior in an Industrial Single Snorkel Refining Furnace (SSRF): The Effect of Gas Injection Position and Snorkel Diameter |
8 |
| Effect of Nut Coke Addition on Physicochemical Behaviour of Pellet Bed in Ironmaking Blast Furnace |
8 |
| Quantitative Analysis of Mineral Phases in Iron-ore Sinter by the Rietveld Method of X-ray Diffraction Patterns |
8 |
| Dissolution Mechanism of Carbon Brick into Molten Iron |
7 |
| Effect of Cooling Rate on the Solidification Microstructure and Characteristics of Primary Carbides in H13 Steel |
7 |
| Influence of Al/Ti Ratio in Ti-ULC Steel and Refractory Components of Submerged Entry Nozzle on Formation of Clogging Deposits |
7 |
| Change in Composition of Inclusions through the Reaction between Al-killed Steel and the Slag of CaO and MgO Saturation |
7 |
| Detection Method for Pulverized Coal Injection and Particles in the Tuyere Raceway Using Image Processing |
7 |
| Thermodynamic Modeling of the SFCA Phase Ca-2(Fe,Ca)(6)(Fe,AI,Si)(6)O-20 |
7 |
| Holdup Characteristics of Melt in Coke Beds of Different Shapes |
7 |
| Improving Blast Furnace Raceway Blockage Detection. Part 3: Visual Detection Based on Tuyere Camera Images |
7 |
| Physical and Mathematical Modeling of Multiphase Flows in a Converter |
7 |
| Comparison between Reducibilities of Columnar Silico-ferrite of Calcium and Aluminum (SFCA) Covered with Slag and Acicular SFCA with Fine Pores |
7 |
| Effect of the Surface Layer Strained by Mechanical Grinding on X-ray Diffraction Analysis |
6 |
| Texture Evolution during Recrystallization and Grain Growth in Heavily Cold-rolled Fe-3%Si Alloy |
6 |
| Transient Thermo-fluid and Solidification Behaviors in Continuous Casting Mold: Evolution Phenomena |
6 |
| Improving Blast Furnace Raceway Blockage Detection. Part 2: Signal Processing of Hot Blast Pressure Data |
6 |
| Recovery of Fe, Ni, Co, and Cu from Nickel Converter Slag through Oxidation and Reduction |
6 |
| Iron Powders from Steel Industry by-products |
6 |
| Application of Phenomenological Theory to Chemical Metallurgy |
6 |
| Randomization of Ferrite/austenite Orientation Relationship and Resultant Hardness Increment by Nitrogen Addition in Vanadium-microalloyed Low Carbon Steels Strengthened by Interphase Precipitation |
5 |
| Tensile Properties of an Electrolytically Hydrogen Charged Duplex Stainless Steel Affected by Strain Rate |
5 |
| Correction of Elastic Anisotropy in Williamson-Hall Plots by Diffraction Young's Modulus and Direct Fitting Method |
5 |
| Evolution Mechanism of Inclusions in Al-killed, Ti-bearing 11Cr Stainless Steel with Ca Treatment |
5 |
| Research on the Bimetallic Composite Roll Produced by an Improved Electroslag Cladding Method: Mathematical Simulation of the Power Supply Circuits |
5 |
| A Kinetic Model of Mass Transfer and Chemical Reactions at a Steel/Slag Interface under Effect of Interfacial Tensions |
5 |
| Interactive Relationship between the Superheat, Interfacial Heat Transfer, Deposited Film and Microstructure in Strip Casting of Duplex Stainless Steel |
5 |
| Effect of Main Gas Composition on Flow Field Characteristics of Supersonic Coherent Jets with CO2 and O-2 Mixed Injection (COMI) at Steelmaking Temperature |
5 |
| Effect of Crystallization on the Abrupt Viscosity Increase during the Slag Cooling Process |
5 |
| Radar Detection-based Modeling in a Blast Furnace: a Prediction Model of Burden Surface Shape after Charging |
5 |
| A Novel Method for Improving Cast Structure of M42 High Speed Steel by Pressurized Metallurgy Technology |
5 |
| Oxidation of Ti Added ULC Steel by CO Gas Simulating Interfacial Reaction between the Steel and SEN during Continuous Casting |
5 |
| Fundamentals of Silico-Ferrite of Calcium and Aluminium (SFCA) Iron Ore Sinter Bonding Phase Formation: Effects of Titanium on Crystallisation during Cooling |
5 |
| Fundamentals of Silico-Ferrite of Calcium and Aluminium (SFCA) Iron Ore Sinter Bonding Phase Formation: Effects of Basicity and Magnesium on Crystallisation during Cooling |
5 |
| Effect of Brazing Temperature on Microstructure and Mechanical Property of High Nitrogen Austenitic Stainless Steel Joints Brazed with Ni-Cr-P Filler |
5 |
| Transformation Behavior of Bainite during Two-step Isothermal Process in an Ultrafine Bainite Steel |
5 |
| Effect of Annealing Temperature on the Selective Oxidation and Reactive Wetting of a 0.1C-6Mn-2Si Advanced High Strength Steel During Continuous Galvanizing Heat Treatments |
5 |
| Mathematical Modelling of the Effects of Transient Phenomena on Steel Cleanness during Tundish Transfer Practices |
5 |
| Dissolution Behavior of Mg from MgO-C Refractory in Al-killed Molten Steel |
5 |
