| Effect of microalloying with silicon on high temperature oxidation resistance of novel refractory high-entropy alloy Ta-Mo-Cr-Ti-Al |
10 |
| The effect of recycling on the oxygen distribution in Ti-6Al-4V powder for additive manufacturing |
9 |
| Effect of test atmosphere composition on high-temperature oxidation behaviour of CoNiCrAlY coatings produced from conventional and ODS powders |
7 |
| Characterization of chromia scales formed n supercritical carbon dioxide |
6 |
| Rate-dependent low cycle fatigue and ratcheting of 25Cr2MoVA steel under cyclic pulsating tension |
6 |
| Creep behaviour of AISI 316H stainless steel under stress-varying creep loading conditions: primary creep regeneration |
5 |
| A study of breakaway oxidation of 9Cr-1Mo steel in a Hot CO2 atmosphere using Raman spectroscopy |
4 |
| High-temperature behavior of oxide dispersion strengthening CoNiCrAIY |
4 |
| The creep and fracture behaviour of tempered martensitic steels |
4 |
| Effect of W-Mo balance on long-term creep life of 9Cr steel |
3 |
| The influence of chromium on early high temperature corrosion of ferritic alloys under SO2 atmosphere |
3 |
| Analysis of creep deformation and damage behaviour of 304HCu austenitic stainless steel |
3 |
| Microstructure and property evolutions of a novel Super304H steel during high temperature creeping |
3 |
| Hot corrosion: a modification of reactants causing degradation |
3 |
| Stress corrosion of Ni-based superalloys |
3 |
| Alumina formation and microstructural changes of aluminized CoNiCrAlY coating during high temperature exposure in the temperature range 925 degrees C-1075 degrees C |
3 |
| Small punch and uniaxial creep fracture behaviours of modified SUS304H steel at various temperatures |
3 |
| Effects of Si, Mn, and water vapour on the microstructure of protective scales grown on Fe-20Cr in CO2 gas |
3 |
| High temperature behavior of diffusion aluminide coating on alloy 600 superalloy |
3 |
| Effect of W-Mo balance and boron nitrides on creep rupture ductility of 9Cr steel |
3 |
| Precipitation study in Ti-stabilised austenitic stainless steel after 000 h of service |
3 |
| Corrosion behavior of candidate heat exchanger materials in oxidizing and reducing gases relevant to oxyfuel power plants |
3 |
| Life assessment of SiMo 4.06 cast iron under LCF and TMF loading conditions |
2 |
| Effect of Co on the microstructure evolution of modified HR3C austenitic heat-resistant steels during long-term ageing |
2 |
| Microstructural and phase characterisation of pyrolytic graphite coating by CVD using propane and methane as precursor |
2 |
| Possible scenarios for the causes of accelerated fireside corrosion of superheater tubes in coal-fired boilers |
2 |
| Influence of Aging treatment on the microstructure and mechanical properties of T92/Super 304H dissimilar metal welds |
2 |
| Temperature effect on the role of yttrium in oxidation behaviour of NiCrAl alloys |
2 |
| Oxidation behaviour of steels in advanced gas cooled reactors |
2 |
| An investigation on oxidation/carburisation of 9Cr-1Mo steel heat exchanger tube in an AGR environment |
2 |
| Modification of the reactive synthesis of porous FeAl with addition of Si |
2 |
| PVD thermal barrier coating systems for Mo-Si-B alloys |
2 |
| The effect of Ni additions on the oxidation behaviour of Co-Re-Cr high-temperature alloys |
2 |
| Effect of microstructure on KCI corrosion attack of modified AISI 310 steel |
2 |
| Microstructural investigations of Ni and Ni2Al3 coatings exposed n biomass power plants |
2 |
| Characterization of pack cemented Ni(2)Al(3 )coating exposed to KCl(s) induced corrosion at 600 degrees C |
2 |
| The role of superalloy precipitates on the early stages of oxidation and type II hot corrosion |
2 |
| Oxidation and chromia evaporation of austenitic steel TP347HFG in supercritical water |
2 |
| A critical-plane-based thermomechanical fatigue lifetime prediction model and its application in nickel-based single-crystal turbine blades |
2 |
| Advanced constitutive modelling for creep-fatigue assessment of high temperature components |
2 |
| Manifestations of dynamic strain aging under low and high cycle fatigue in a type 316LN stainless steel |
2 |
| Use of the Wilshire equation to correlate and extrapolate creep rupture data of Incoloy 800 and 304H stainless steel |
2 |
| Elevated temperature fatigue behaviour of structural materials for advanced ultra supercritical application |
2 |
| The influence of heat treatment and strain rate on the third type strain ageing phenomenon |
2 |
| Numerical simulation and life prediction on T22 boiler tubes with steam-side and fire-side oxide scale |
2 |
| Prediction of surface oxidation weight gain on 7.8 wt% Cr-containing stainless steel electrode during electroslag remelting |
2 |
| Mechanical behaviour of conventional, Pt- and Pt/Ir-modified NiAl diffusion coatings after thermocyclic exposure at 1100 degrees C |
2 |
| Procedures for handling computationally heavy cyclic load cases with application to a disc alloy material |
2 |
| Quantitative study of microstructure evolution and the effect on mechanical properties of Super304H during aging |
1 |
| Effect of creep lifetime on geometric optimization of boiler tubes for thermal power plants |
1 |
