| Numerical Analysis for the BinghamPapanastasiou Fluid Flow Over a Rotating Disk |
7 |
| Similarity Laws in Laser Cladding of Cermet Coatings |
6 |
| Investigation of Flow Characteristics And Heat Transfer Enhancement in a Nanofluid Flow in a Corrugated Duct |
6 |
| Penetration of Steel Projectiles through Finite-Thickness Ice Targets |
6 |
| Numerical Simulation of Viscous Dissipation in a Micropolar Fluid Flow through a Porous Medium |
5 |
| Effect of Radiative Heat Transfer and Boundary Conditions on the Airflow and Temperature Distribution Inside a Heated Tunnel Greenhouse |
4 |
| Effect of Heat Treatment on Mechanical and Microstructural Properties of the Welded Joint of the Al-Mg-Li Alloy Obtained by Laser Welding |
4 |
| PHYSICOCHEMICAL PROCESSES IN THE INTERACTION OF AEROSOL WITH THE COMBUSTION FRONT OF FOREST FUEL MATERIALS |
4 |
| Direct Numerical Simulation of Homogeneous Isotropic Helical Turbulence with the TARANG Code |
4 |
| EFFECT OF THE DOWNSTREAM CRESCENT-SHAPED BLOCK HEIGHT ON THE FLAT-PLATE FILM FLOW AND COOLING PERFORMANCE |
3 |
| LIFT FORCE ACTING ON A HEAVY SOLID IN A ROTATING LIQUID-FILLED CAVITY WITH A TIME-VARYING ROTATION RATE |
3 |
| Quasi-Hydrodynamic Model of Multiphase Fluid Flows Taking into Account Phase Interaction |
3 |
| Control of the Formation of a Transonic Region in a Supersonic Flow by Using a Throttling Jet and Near-Wall Heat Release |
3 |
| Formation of Regions with High Energy and Pressure Gradients at the Free Surface of Liquid Dielectric in a Tangential Electric Field |
3 |
| Three-Dimensional Thermo-Elastic Analysis of a Rotating Cylindrical Functionally Graded Shell Subjected to Mechanical and Thermal Loads Based on the FSDT Formulation |
2 |
| Flow and Heat Transfer in a High-Aspect-Ratio Rib-Roughed Cooling Channel with Longitudinal Intersecting Ribs |
2 |
| Recovery of Methane From Gas Hydrates in a Porous Medium by Injection of Carbon Dioxide |
2 |
| Asymptotic Formula for the Spectrum of the Linear Problem Describing Periodic Polymer Flows in an Infinite Channel |
2 |
| Creating a Coating from a Titanium-Aluminum Intermetallic Compound By the Cold Spray Technology |
2 |
| Local Adiabatic Heating Effect in Finite-Strain Elastic-Plastic Torsion |
2 |
| Dynamic Buckling of a Cylindrical Shell with a General Boundary Condition under an Axial Impact |
2 |
| Methods for Studying the Sensitivity of Air Quality Models and Inverse Problems of Geophysical Hydrothermodynamics |
2 |
| Effect of a Passive Swirler on Superheated Liquid Outflow |
2 |
| Long-Run Testing of Model Nozzle Extensions Made of a Carbon-Carbon Composite Material in a Liquid-Propellant Rocket Engine Operating on Hydrogen and Oxygen |
2 |
| Plane Harmonic Waves in Thermoelastic Materials with a Memory-Dependent Derivative |
2 |
| EXACT SOLUTIONS OF THE BOLTZMANN EQUATIONS WITH A SOURCE |
2 |
| BEHAVIOR OF A SEMI-INFINITE ICE COVER UNDER A UNIFORMLY MOVING LOAD |
2 |
| NATURAL CONVECTION HEAT TRANSFER IN 2D AND 3D TRAPEZOIDAL ENCLOSURES FILLED WITH NANOFLUID |
2 |
| SOLUTION OF A PLANE HYDROFRACTURE PROBLEM WITH STRESS CONTRAST |
2 |
| MODELING OF THE INSTALLATION AND STABILITY OF GEL BARRIERS IN MAIN FRACTURES |
2 |
| Effect of Surface Layer Damage on Acoustic Anisotropy |
2 |
| Film Cooling Performance for Cylindrical Holes Embedded in Contoured Craters: Effect of the Crater Depth |
2 |
| PROTEIN FOLDING DYNAMICS IN THE SPACE OF EXPERIMENTALLY MEASURED VARIABLES: TURBULENCE PHENOMENA |
2 |
| Calculation of the Unsteady Thermal Stresses in Elastoplastic Solids |
2 |
| Numerical Simulation and Experimental Study of Plastic Strain Localization under the Dynamic Loading of Specimens in Conditions Close to a Pure Shear |
2 |
| Dynamics of Separation Points Upon Impact of a Floating Circular Cylinder |
2 |
| Entropy Analysis of a Convective Film Flow of a Power-Law Fluid with Nanoparticles Along an Inclined Plate |
2 |
| Theoretical-Experimental Study of the Interior Ballistics of an Electrothermal Accelerator of Macrobodies |
1 |
| Casson Fluid Flow Due to Non-Coaxial Rotation of a Porous Disk and the Fluid at Infinity Through a Porous Medium |
1 |
| Stokes Flow Through a Membrane Built up by Nonhomogeneous Porous Cylindrical Particles |
1 |
| TEMPERATURE EFFECT ON THE FRACTURE OF LASER WELDED JOINTS OF AVIATION ALUMINUM ALLOYS |
1 |
| Simulation of Primary Film Atomization Due to Kelvin-Helmholtz Instability |
1 |
| GENERALIZATION OF A PRANDTL SLOPE FLOW MODEL WITH A HEAVY ADMIXTURE |
1 |
| INFLUENCE OF PRECURSOR GAS FLOW RATE ON FLUOROPOLYMER COATING GROWTH RATE DURING HOT WIRE CHEMICAL VAPOR DEPOSITION |
1 |
| Evaluation of the Temperature Regime of the Rods of the Inductor of an MHD Stirrer for Possible Use in an Industrial Aluminum Furnace |
1 |
| Stability of Thermovibrational Convection of a Pseudoplastic Fluid in a Plane Vertical Layer |
1 |
| Excitation of Convection in a System of Layers of a Binary Solution and an Inhomogeneous Porous Medium in a High-Frequency Vibration Field |
1 |
| ANALYTICAL MODEL FOR DETERMINING THE EFFECTIVE SIZE OF AN EVAPORATION REGION IN PULSED LASER ABLATION |
1 |
| FORMATION AND EVAPORATION OF NEAR-WALL LIQUID FILMS UNDER EXPANSION FROM A NOZZLE INTO VACUUM |
1 |
| SYNTHESIS OF DIAMONDS FROM THE MICROWAVE PLASMA WITH THE USE OF SUPERSONIC GAS FLOWS |
1 |
